Pipefitting Course 200
The course provides all the necessary knowledge to be able to work in the process industries such as Oil and Gas, Petrochemicals, as an entry-level Pipefitter/ Fabricator gaining the skills to perform threading, fabrication of welded pipe spools in a single plane and two plane spools, Calculate cutting lengths of materials, mark out by measuring, cutting and preparation of pipe ends, understand rigging and slinging methods, calculate loads, H & S in the workplace, permit systems. Dis assemble clean and reassemble piping systems and then pressure test Hydrostatically to check for leak-free builds
Final Exams (All Units)
This section contains the final examinations for all units of the Pipefitting course 200.
Each exam evaluates the knowledge and skills covered in its respective unit.
Please read all questions carefully and ensure that you answer all questions before submitting your attempt.
LXR (Units 201 & 206)
This section contains the LXR assessments for Units 201 and 206 of the Pipefitting course 200. Each exam evaluates the knowledge and skills covered in each unit. Please read all questions carefully and ensure that you answer all questions before submitting your attempt.
Practical Performance Test
This practical performance test evaluates the trainee’s ability to apply the skills and procedures learned in the Pipefitting course 200. Trainees will be assessed based on their performance, accuracy, and safety practices during the task. Please read the instructions carefully before starting the test.